Expert Shutters In Port St. Lucie | Whether you want to get some privacy or control the amount of sunlight entering your house, window blinds are a practical and affordable solution. When it comes to the installation of window blinds, you can take the assistance of professionals, they will measure your windows and get the shades installed.
While hiring professionals seems logical if you have a large number of windows, but installing shades is quite easy and you can install window treatments in Port St. Lucie yourself and save some of your money. Here are some tips to help you install the shades by yourself.
Decide the type of blinds you want
Before you go to purchase a window treatment, decide what kind of shade do you want to install in your window. Take a good look at your window and decide for yourself if an indoor blind would look better or an outdoor blind on your window. Inside mounted shades look more neat and tidy and outside mounted window blinds work great when the window frame is too shallow to adjust the mounting brackets.
Measure the window
If you want to install expert shutters in Port St. Lucie that is just the right fit for your window, then you need to measure your windows correctly. If you’re planning to install inside mount blinds then measure the width of the window frame and select a blind that fits the measurement. The same goes for outside mounted blinds, measure the width that you want to cover and get a blind that meets the requirements. Blinds can also be custom made to fit your specific dimensions.
Ready the tools and hardware
To install a window blind, you’ll need some tools and equipment like a screwdiver, measuring tape, level, anchors and a step stool or ladder. Have all the necessary tools ready and at your disposal before you begin installing the shades.
Read all the instructions
After you have ordered and received your window blind open the box very carefully and lay all the part out. Once you have laid down all the parts, open the instruction manual and go through each point very carefully. These instructions are not very long but you need to read them thoroughly to understand properly the order in which you will complete the installation.
Drill the holes
Now it is time to drill the holes to mount the blinds. Use the tape and measure to mark the points where you want to drill the hole, measure twice if you want to be sure where to drill the holes. You can also use a ladder or step stool here if the frame is a bit high. Once you are sure as to where you want the pilot holes to be, use a drill to make the holes.
Install brackets
Take the blind mounting brackets and align it with the hole that you have just drilled and fix the mounting screws to attach the bracket. Repeat the same procedure for all the brackets and if you don’t have a drill then you can also use a screwdriver to install the bracket, although it might take a long time and become quite a bit difficult to install.
Check the brackets
Once you have installed the mounting brackets, you can measure the levels again to make sure that you have installed the brackets in the right alignment. Take the level and hold it across two brackets to check if it is installed correctly. If the level doesn’t cover the distance between the two mounting brackets then you can take a straight-edged board that fits the span and hold the level against the bottom edge of the board and then check the bubble.
Clip the shades and check its operation
To clip the shades, loosen the small screws on the bottom of the mounting brackets. Now you can clip the shade into the protruding lip of the two brackets on the edge of the headrail. Now push the headrail back towards the window and tighten the screws to lock the shades in place. Once the shade is nicely fixed, check its operation and see if it’s running smoothly.